LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2009 >> LR2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission RWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- XF/X260) >> Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission RWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD >> Transfer Case Rear Output Seal >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XF and 2017 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Refer to: Rear Driveshaft - AWD
  3. CAUTION:
    • Discard the nut.
    • Discard the seal.
    G11314279

    Special Tool(s):  205-053

  4. G11314280

    Using a suitable tool, remove the output flange.

  5. WARNING: Be prepared to collect escaping oil.
    G11314281

    Carefully remove and discard the oil seal.

  6. CAUTION: Make sure that the Jaguar approved cleaning fluid (Loctite 7063) is used to clean the mating faces.
    G11314282

    Make sure to thoroughly clean the output flange splines.

  7. G11314283

    Clean the seal register and thoroughly inspect for damage.

scientia non olet · About LEMON Manuals