LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2009 >> LR2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission RWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- XF/X260) >> Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission RWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD >> Transfer Case Actuator >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XF and 2017 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Install new O-ring seals.

    Install the transfer case actuator.

    Renew Part: Transfer case actuator O-ring seals. 

    Torque Specification:  : 10 Nm 

  2. Connect the connector.
  3. CAUTION: Do not fully tighten the bolts at this stage.

    Install the cross member.

  4. Install the cross member to transfer case retaining bolt.

    Torque Specification:  : 110 Nm 

  5. CAUTION: Do not fully tighten the bolts at this stage.

    Fully tighten the cross member retaining bolts.

    Torque Specification:  : 48 Nm 

  6. Connect the wiring harness.
  7. Install the heat shield.
  8. Fill the transfer case.

    Refer to: Transfer Case Draining and Filling 

  9. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect

    • Connect Jaguar Land Rover approved diagnostic equipment.
    • Clear any Diagnostic Trouble Codes (DTCs).
    • Start the diagnostic service function "transfer case-transfer case replacement".
    • Using the diagnostic tool, calibrate the component.
    • Clear any Diagnostic Trouble Codes (DTCs) after calibration and check for correct operation.
scientia non olet · About LEMON Manuals