Pinpoint Test E: Fuel System Priming Tests

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.

E1: FUEL SYSTEM PRIMING TEST 1
1. Set the ignition to off.
2. Wait at least 30 seconds (to allow the control modules to shut down).
  NOTE: The fuel pump should prime the fuel system when the ignition is set to on.
3. Set the ignition to on.
4. Using the manufacturer approved diagnostic system, check datalogger signal - Fuel Rail Pressure Low Range Sensor (0x0376).
Is the fuel pressure value greater than 2.0 V?
- Yes : GO to Pinpoint Test F .
- No : GO to Pinpoint Test G .