System Operation: Service

WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.

Functional Test

The EPB module incorporates a vehicle inspection mode that allows a functional test of the parking brake to be performed on a rolling brake tester.

For additional information, refer to: Parking Brake

Brake Pad Replacement

To change the rear brake pads it is necessary to fully retract the thrust nut to allow retraction of the caliper piston. This can be done using one of the following methods:

Putting the EPB module into the maintenance mode using Land Rover approved diagnostic equipment.
Putting the EPB module into the maintenance mode without diagnostic equipment.
Using a special tool to mechanically retract the brake pads.

For additional information, refer to: Brake Pads - LHD AWD/RHD AWD