LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2008 >> LR2 HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Parking Brake & Actuation -- LR2/L359) >> Parking Brake And Actuation >> Electronic Parking Brake Service Mode Activation And Deactivation >> General Procedures >> Activation

General Procedures: Activation

WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system released.
NOTE: This procedure allows the parking brake to be released when removing and installing new rear brake pads or brake discs.
  1. Press and hold the parking brake switch in the release position.
  2. Wait 2 seconds.
  3. Press and hold the accelerator pedal in the wide open throttle position.
  4. Wait 2 seconds.
  5. Turn the ignition Off and back On immediately.
    NOTE: An audible noise will be heard to confirm that the parking brake has been released in Service Mode.
  6. Release the accelerator pedal and release the parking brake switch to the neutral position.
    NOTE: An audible noise will be heard to confirm that the parking brake has been released in Service Mode.
scientia non olet · About LEMON Manuals