LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2008 >> LR2 HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Supercharger Cooling (V8 S/C 5.0L Petrol)) >> Supercharger Cooling (V8 S/C 5.0L Petrol) >> Removal And Installation >> Coolant Pump >> Removal

Coolant Pump: Removal

WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure.
CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
NOTE: This procedure covers the removal and installation of the supercharger auxiliary coolant pump.
  1. Refer to Specifications .
  2. Refer to Engine Cover - 5.0L NA V8 - AJ133/5.0L SC V8 - AJ133 .
  3. Refer to Air Cleaner LH .
  4. See figure
    GJ0012950
    5. CAUTION: Be prepared to collect escaping coolant.
    CAUTION: Make sure that all openings are sealed. Use new blanking caps.
    NOTE: Clamp both auxiliary coolant pump coolant hoses to minimize coolant loss.
  5. See figure
    GJ0012951
    6. CAUTION: Be prepared to collect escaping coolant.
  6. See figure
    GJ0012952
    7. WARNING: Make sure to support the vehicle with axle stands.
  7. Raise and support the vehicle.
  8. See figure
    GJ0012953
  9. See figure
    GJ0012113
  10. See figure
    GJ0012954
  11. See figure
    GJ0012955
scientia non olet · About LEMON Manuals