Coolant Pump: Installation
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Torque: 6 Nm
- See figure
- See figure
- Torque:
10 Nm
62 Nm
- Lower the vehicle.
- See figure
- See figure
- Torque: 3.5 Nm
- Refer to Air Cleaner LH .
- See figure
- When coolant runs from the bleed point bubble-free, tighten the bleed screw.
- Check and top-up the coolant.
- Refer to Specifications .
- Start the engine and allow to run for 30 seconds, stop the engine.
- Check and top-up the coolant.
- Refer to Engine Cover - 5.0L NA V8 - AJ133/5.0L SC V8 - AJ133 .
CAUTION:
Damage to the charge air cooler coolant pump will occur if the pump is allowed to cavitate.
NOTE:
With the ignition on the charge air coolant pump will run, to aid coolant bleed. Make sure the charge air coolant pump is primed prior to running the pump.