Diagnostic Aids
- If DTC P0130, P0136, P0150 or P0156 is set, there is a circuit malfunction, caused by the stoichiometric ratio of suspect sensor is outside normal operating range.
- If DTC P0131, P0137, P0151 or P0157 is set, the sensor signal voltage is less than expected, caused by a sensor circuit short to ground.
- If DTC P0132, P0138, P0152 or P0158 is set, the sensor signal voltage is more than expected, caused by a sensor circuit short to battery voltage.
- If DTC P0133 or P0153 is set, the front sensor is aged, indicated by a slow responding sensor signal that is either too long or too short.
- If DTC P0134, P0140, P0154 or P0160 is set, no sensor activity is detected, caused by an open circuit.
- If DTC P0135, P0141, P0155 or P0161 is set, there is a sensor heater circuit malfunction, caused by an open or short circuit.
- If DTC P1129 is set, the front sensor connectors have been swapped side to side.
- If DTC P1170 or P1173 is set, there is a downstream fuel trim malfunction caused by a front sensor that is aged, indicated by a rear HO2S adaptation that is too lean or too rich.