LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2002 >> Range Rover >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instruments - Description & Operation >> Description >> Service Interval Indicator >> SII Reset Procedure >> SII Reset Procedure (All Except Japan and NAS)

SII Reset Procedure (All Except Japan and NAS)

  1. Ensure that the ignition is switched off.
  2. Press and hold the LH instrument pack button.
  3. With the button held, switch the ignition on to position I (AUX).
  4. Continue to hold the LH instrument pack button for a further 5 seconds, until the "SIA RESET" appears.
  5. The message center will display the distance to service status as "RESET SIA: 3600km/mls" and the type of service (OIL SERVICE or INSPECTION).
  6. Check that the reset distance limit has been reached.
    1. If yes, proceed to step  9.
    2. If no, proceed to step 7.
  7. Press the LH button once. The message center will display the date to service status as "RESET SIA: 03.12".
  8. Check that the reset date limit has been reached.
    1. If yes, proceed to step  11.
    2. If no, proceed to step  10.
  9. When the distance reset limit has been reached or exceeded, press and hold the LH button for 5 seconds. "RESET" flashes in the message center five times.
    1. If the LH button is not pressed again before the fifth flash of "RESET", the reset will not be performed. The message center will display "END SIA: 3600 km/miles" for 5 seconds and the display will change to the service date "RESET SIA: 12.03".
    2. If the LH button is pressed before the fifth flash of "RESET", the service distance will be reset. The message center will display the new service distance "END SIA: 25000 km/miles" for 5 seconds. The service date will then be displayed.
  10. Press the LH button once. The message center will display "END SIA" for 2 seconds. This ends the service interval check and reset.
  11. When the date reset limit has been reached or exceeded, press and hold the LH button for 5 seconds. "RESET" flashes in the message center five times.
    1. If the LH button is not pressed again before the fifth flash of "RESET", the reset will not be performed. The message center will display "END SIA: 12.03" for 5 seconds. "END SIA" will be displayed for a further 2 seconds and the service interval and check will be ended.
    2. If the LH button is pressed before the fifth flash of "RESET", the service date will be reset. The message center will display the new service date "END SIA: 12.04" for 5 seconds. "END SIA" will be displayed for a further 2 seconds and the service interval and check will be ended.
  12. Switch the ignition off.
scientia non olet · About LEMON Manuals