LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2000 >> Range Rover Base >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Self-Diagnostics - With Codes >> Diagnostic Tests (BOSCH) >> Repair Confirmation Drive Cycle >> Repair Confirmation Drive Cycle "A"

Repair Confirmation Drive Cycle "A"

  1. After completing DTC and/or complaint repairs, allow engine to cool. Install Land Rover TestBook or OBD-II scan tool. Turn ignition on for 30 seconds. Ensure Engine Coolant Temperature (ECT) sensor indicates less than 140°F (60°C).
  2. Start engine and allow to idle for 2 minutes. Check for DTCs using Land Rover TestBook or OBD-II scan tool. If any DTC is indicated, perform specified repairs. See DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION (BOSCH) table in SELF-DIAGNOSTICS - INTRODUCTION article. If no DTCs are indicated, repair is complete.
scientia non olet · About LEMON Manuals