Tailpipe

Tailpipe

Service Repair No - 30.10.22

Removal
1. Raise vehicle on a ramp.





2. Remove 2 nuts securing tail pipe to intermediate pipe.





3. Release tail pipe from mounting rubber.
4. Release tail pipe from intermediate pipe and feed over rear axle.
5. Remove tail pipe.

Installation
1. Feed tail pipe over rear axle and connect to intermediate pipe.
2. Secure tail pipe to mounting rubber.
3. Fit (install) nuts and tighten tail pipe to intermediate pipe 30 Nm (22 ft. lbs.).
4. Lower vehicle.