LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 1990 >> Range Rover County >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Air Suspension - 3.9L & 4.2L >> Removal & Installation >> Reservoir Pressure Switch >> Installation

Reservoir Pressure Switch: Installation

  1. Apply Loctite 572 to thread of pressure switch.
  2. Fit pressure switch and tighten to 23 N.m (17 ft. lbs.).
  3. Connect multi-plug and battery.
  4. Start engine to re-pressurize system.
  5. Attain standard ride height.
  6. Leak test pressure switch. See LEAK TEST PROCEDURE  under TROUBLE SHOOTING.
scientia non olet · About LEMON Manuals