LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 1990 >> Range Rover County >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Air Suspension - 3.9L & 4.2L >> Removal & Installation >> Front Damper >> Removal

Front Damper: Removal

WARNING: Air suspension is pressurized up to 10 bar. Dirt or grease must not enter system. Wear hand, ear and eye safety standard protection when servicing system.
WARNING: Unrestricted movement of a pressurized air spring will result in failure of assembly, causing component damage and possible personal injury. It is possible to remove damper assembly without depressurizing air springs, providing distance between axle and chassis is held as if damper assembly were still fitted. This is achieved by supporting vehicle on stands with a jack under axle.
  1. Disconnect negative battery cable.
  2. Remove wheel.
  3. Support chassis on axle stands.
  4. Support front axle with jack.
    5. CAUTION: Do not lower axle when damper is removed, this may result in damage to air springs.
  5. Remove top and bottom damper fixings. See Fig 1 .
  6. Remove damper. See Fig 1 .
Fig 1: Removing Front Damper
G00089010Courtesy of LAND ROVER NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals