Air Pipe: Installation
NOTE:
Air pipe may be trimmed if sufficient straight pipe remains. Ensure pipe end is cut square, without distortion or frays to obtain air tight seal. Lightly chamfer pipe using a pencil sharpener after cutting. DO NOT cut pipes more than twice.
- Push pipe firmly through 2 "O" rings until it contacts base of housing as shown. See Figure . Gently pull pipe to ensure connection. The collet will retain some movement while depressurized. Install rubber boot.
- Pressurize system. Refer to DEPRESSURIZING & PRESSURIZING SYSTEM under SERVICING.
- Leak test connection. Refer to LEAK TEST PROCEDURE under TROUBLE SHOOTING.