Monitor KDS Data

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Ignition switch "OFF". Connect KDS to Data Link Connector (DLC). Ignition switch "ON". Monitor "Diagnostic Trouble Codes (DTC)" with KDS. Clear any DTCs stored in the system with KDS. Re-check DTC in the system with KDS. Did the same DTC is stored in the system?	-

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

No Good

If no problems were found with the circuits or connectors, replace the AWD ECU and Go to "VERIFICATION OF REPAIR " procedure.
* In case of replacing AWD ECU, perform following "S/W Management" procedures.
If no problems were found with the circuits or connectors, replace CLU and then Go to "VERIFICATION OF REPAIR " procedure.