Removal And Installation: Installation

Install in the reverse order of removal.

NOTE:

When installing, apply the ATF oil or petroleum jelly to the O-rings (A) to prevent damage.

G15693797

Courtesy of KIA MOTORS AMERICA, INC.

The existing valve body cover gasket (A) must be replaced with a new one (do not reuse).

G15693798

Courtesy of KIA MOTORS AMERICA, INC.

Perform the procedures below after installing.
1. Refill the automatic transaxle fluid.
  (Refer to Hydraulic System - "FLUID ")
2. Refill the coolant.
  (Refer to Engine Mechanical System - "COOLANT ")
3. Clear the diagnostic trouble codes (DTC) using the KDS.
  Disconnecting the battery negative terminal will not clear the DTCs. Clear DTCs using the KDS at all times.
4. After installing, check for leakage of fluid from hose connection during engine starting and running.