C-CAN Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
MDPS connector | 7 (C-CAN high) | MDPS connector | 8 (C-CAN low) | Approx. 60Ω |
| ICU (component side) | 29 (C-CAN high) | ICU (component side) | 30 (C-CAN low) | Approx. 120Ω | |
| Instrument CLU (component side) | 32 (C-CAN high) | Instrument CLU (component side) | 33 (C-CAN low) | Approx. 120Ω | |
| MDPS connector | 7 (C-CAN high) | CLU connector | 29 (C-CAN high) | Approx. below 1Ω | |
| MDPS connector | 8 (C-CAN low) | CLU connector | 30 (C-CAN low) | Approx. below 1Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace Instrument cluster and then Go to "VERIFICATION OF REPAIR " procedure.