C-CAN inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
MDPS connector | 7 (C-CAN high) | MDPS connector | 8 (C-CAN low) | Approx. 60Ω |
| MFC connector | 12 (C-CAN high) | MFC connector | 4 (C-CAN low) | Approx. 60Ω | |
| MDPS connector | 7 (C-CAN high) | MFC connector | 12 (C-CAN high) | Approx. below 1Ω | |
| MDPS connector | 8 (C-CAN low) | MFC connector | 4 (C-CAN low) | Approx. below 1Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the MFC and then Go to "VERIFICATION OF REPAIR " procedure.