Circuit Inspection

G15717753

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Item	Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Item	Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Open in circuit inspection (P-SIS - passenger ↔ SRSCM)	Ignition "OFF". Disconnect the 12V battery (-) cable and wait at least for five minutes. Disconnect P-SIS - passenger connector, SRSCM connector.	P-SIS - passenger connector	1 (high)	SRSCM connector	46 (high)	Approx. below 1Ω
Open in circuit inspection (P-SIS - passenger ↔ SRSCM)		P-SIS - passenger connector	2 (low)	SRSCM connector	45 (low)	Approx. below 1Ω
Short in circuit inspection (P-SIS - passenger ↔ Chassis ground)	Ignition "OFF". Disconnect the 12V battery (-) cable and wait at least for five minutes. Disconnect P-SIS - passenger connector.	P-SIS - passenger connector	1 (high)	Chassis ground	-	∞ (infinity)Ω
		P-SIS - passenger connector	2 (low)	Chassis ground	-	∞ (infinity)Ω
Oscilloscope (P-SIS - passenger)	Ignition "OFF". Disconnect the 12V battery (-) cable and wait at least for five minutes. Disconnect P-SIS - passenger connector. Connect the 12V battery (-) terminal cable to the 12V battery. Ignition "ON".	P-SIS - passenger connector	1 (high)	Chassis ground	-	Fig.1
Oscilloscope (P-SIS - passenger)		P-SIS - passenger connector	2 (low)	Chassis ground	-	Fig.1

G15717754

Courtesy of KIA MOTORS AMERICA, INC.

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM main harness and then Go to "VERIFICATION OF REPAIR " procedure.