LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2024 >> Telluride SX X-Line >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (1 Of 4) >> DTC B1363-00: Pretensioner Front-Driver Resistance Circuit Short To Ground >> Wiring Inspection >> Circuit Inspection >> Squib Circuit Inspection

Squib Circuit Inspection

NOTE: If dummy and dummy adaptor are not able to be prepared, use a 2Ω resistor.
  1. Ignition "OFF".
  2. Disconnect the 12V battery (-) cable and wait for 5 minutes or more.
  3. Remove the DBPT module and connect the dummy and dummy adapter to the DBPT module connector.
  4. Connect the 12V battery (-) cable and ignition "ON" and wait for 30s or more.
  5. Connect KDS to Data Link Connector (DLC) and clear DTC with KDS and diagnose again.
  6. Are any DTCs stored in the system?

    Good 

    No Good 

    • Carefully re-do this troubleshooting guide steps.
    • If problem still occurs, replace DBPT module and then Go to "VERIFICATION OF REPAIR " procedure.
scientia non olet · About LEMON Manuals