LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2024 >> Telluride SX X-Line >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System Diagnosis (12 Of 13) >> DTC P2119-00: Throttle Actuator Control Throttle Body Range/Performance >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

Item Detecting Condition Possible Cause
Case 1 DTC Strategy
  • TPS adaptation lower position check
  • Poor connection or damaged harness
  • Faulty ETC motor
Enable Condition
  • During TPS adaptation
  • TPS set point is equal to 1.991 degree
Threshold Value
  • Throttle position for the lower return spring check is not reached within a limit maximum time (Difference between throttle position and set point is greater than 0.503 degree)
Case 2 DTC Strategy
  • TPS adaptation error low return spring check
Enable Condition
  • During TPS adaptation
Threshold Value
  • When ETC power stage is off, throttle cannot return by spring power in the limp-home position within a limit maximum time (Difference between throttle position and adapted voltage in limp-home position is greater than 0.18V)
Case 3 DTC Strategy
  • TPS adaptation upper position check
Enable Condition
  • During TPS adaptation
  • TPS set point is equal to 20.001 degree
Threshold Value
  • Throttle position for the upper return spring check is not reached within a limit maximum time (Difference between throttle position and set point is greater than 0.503 degree)
Case 4 DTC Strategy
  • TPS adaptation error upper return spring check
Enable Condition
  • During TPS adaptation
Threshold Value
  • When ETC power stage is off, throttle cannot return by spring power in the limp-home position within a limit maximum time (Difference between throttle position and adapted voltage in limp-home position is greater than 0.18V)
Case 5 DTC Strategy
  • TPS start check, error in spring check
Enable Condition
  • During TPS start check
  • TPS set-point is equal to 17.003 degree
Threshold Value
  • Throttle flap cannot reach the set point within the hysteresis within a limit maximum time (Difference between throttle position and requested position is greater than 0.5%)
Case 6 DTC Strategy
  • TPS start check error in limp-home check
Enable Condition
  • During TPS start check
  • No engine start condition
Threshold Value
  • When ETC power stage is off, throttle cannot return by spring power in the limp-home position within a limit maximum time (Difference between throttle position and adapted voltage in limp home position is greater than 0.18V)
Diagnostic Time
  • 1.275s
MIL ON Condition
  • 1 driving cycle
scientia non olet · About LEMON Manuals