LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2024 >> Telluride SX X-Line >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System Diagnosis (09 Of 13) >> DTC P0524-00: Engine Oil Pressure Too Low >> System Inspection >> Inspection Procedure >> Check oil pump solenoid operating state

Check oil pump solenoid operating state

  1. Ignition "OFF".
  2. Disconnect the oil pump solenoid connector.
  3. Apply power to Pin No. 1 (power) and connect ground to Pin No. 2 (control) terminal of oil pump solenoid. (component side)
    • Specification:  Operating sound is heard

      Good 

      • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and Go to "VERIFICATION OF REPAIR " procedure.

      No Good 

      • Carefully re-do this troubleshooting guide steps.
      • If no problems were found with the circuits or connectors, replace the oil pump solenoid and Go to "VERIFICATION OF REPAIR " procedure.
scientia non olet · About LEMON Manuals