| DTC Strategy |
- This DTC indicates that a crank shaft reluctor tooth error has not been learned
|
- Poor connections CKPS
- Condition of the target wheel
- ECM
|
| Enable Condition |
- Engine load is between 10% and 90%
- Engine speed is between 1500 and 4000 RPM
- Tooth error correction RPM stability timer is greater than 10s
- Engine coolant temperature is between 0°C (32°F) and 110°C (230°F)
- Not active disabling faults
|
| Threshold Value |
- Distance driven without learning (during fuel cut off) tooth error is greater than 4000 km (2485miles)
- Actual Value is higher or lower than calibrated value
|
| Diagnostic Time |
|
| MIL ON Condition |
|