Inspection Procedure

Tooth Error Correction (TEC) learning
1. Perform TEC learning according to procedure.
  - TEC learning method
  - TEC learning will be completed with fuel cut in a range of over 2, 000 RPM for more than 10s
2. Start the engine.
3. Operate the vehicle within conditions for setting DTC in general information.
Visual check CKPS and target wheel
1. Ignition "OFF".
2. Visually check to see if the CKPS is loose or target wheel is deformed or damaged.
  Good
  - Go to "VERIFICATION OF REPAIR " procedure.
  No Good
  - Carefully re-do this troubleshooting guide steps.
  - If problem still occurs, replace ECM and then Go to "VERIFICATION OF REPAIR " procedure.