High Pressure Fuel Line [Delivery Pipe (Bank 1) Line ↔ Delivery Pipe (Bank 2) Line]

Install in reverse order of removal.
NOTE:
- Replace the cross over high pressure fuel pipe with a new one. (Do not reuse)
- Install the cross over high pressure fuel pipe following order below.
  1. Pre-tighten the both side flange nuts by hand when installing the cross over high pressure fuel pipe.
  2. Tighten the flange nut (bank 2) to the specified torque.
    Tightening torque:
    
    32.4 - 35.3 N.m (3.3 - 3.6 kgf.m, 23.9 - 26.0 lb.ft)
  3. Tighten the flange nut (bank 1) to the specified torque.
    Tightening torque:
    
    32.4 - 35.3 N.m (3.3 - 3.6 kgf.m, 23.9 - 26.0 lb.ft)
Check for fuel leaks after installation.