Head-Up Display (HUD) Unit: Adjustment

If a part of the Head-Up Display (HUD) footage is distorted or it is not at eye level with the driver a KDS can be used to perform calibration.

1. Calibration is required
   • After replacing the head-up display unit
   • When the footage is distorted after replacing the windshield (double vision removal film built-in glass)
   • When the HUD mounted main crash pad is removed/installed or replaced
   • When the image setting location of the HUD unit is not at eye level of the driver resulting in out of focus image
2. Calibration items

   No	Footage calibration functions
   1	Horizontal rotation
   2	Upward/downward
   3	Slope (up/down)
   4	Parallel slope
   5	Vertical movement
   6	Slope (left/right) calibration
   7	Width calibration
   8	Height calibration
   9	Initialization: Return to previous status before calibration

3. Process of calibration
   1. Locate the vehicle on a flat plane for accurate adjustment.
   2. Make sure that there are no foreign materials on the windshield.
   3. Perform the order below with the KDS.

      (S/W Management → Head-Up Display → HUD Calibration)

      NOTE: 'HUD Calibration - initialization' must be performed prior to 'Calibration'.

      Information 

      Refer to the KDS screen for operating conditions and details.