| DTC Strategy |
- Monitor CAN message from MDPS
|
- Poor connector connection
- Abnormal CAN communication circuits (open circuit, short circuit)
- CAN high line open circuit
- CAN low line open circuit
- CAN high and low line open circuit
- CAN high line short circuit to power/ground
- CAN low line short circuit to power/ground
- CAN high, low lines shorted to each other
- Short circuit to ground after CAN high, low lines
- Poor termination resistance
- Transmitting controller bus off
- Transmitting controller disconnected
- Transmitting controller power, fuse or ground fault
- Transmitting controller H/W, S/W fault
- Faulty MDPS
|