| DTC Strategy |
- Monitor DBC switch circuit
|
- Poor connector connection
- Faulty HECU
|
| Enable Condition |
- Normal 12V battery voltage (9 to 16V)
|
| Threshold Value |
- After completion of EPB motor operation, when EPB motor drive "Power-FET" is turned on/off and the monitored voltage exceeds the reference value for more than 1.5s
- Reference value: Below 0.7V (when OFF), greater than battery voltage *60% (when ON)
- After completion of EPB motor operation, when EPB motor drive pre-driver is turned on/off and the monitored voltage exceeds the reference value for more than 1.5s
- Reference value: Below 0.38V (when OFF), between 0.28V and 0.63V (when ON)
|
| Warning Lamp |
|
| Disable Condition |
- When the ignition switch turns off and then on
|