| DTC Strategy |
|
- Poor connector connection
- Sensor off-set error
- Electrical noise signal
- Abnormal off-set of pressure sensor
- Faulty MDPS
|
| Enable Condition |
- Normal 12V battery voltage (9 to 16V)
|
| Threshold Value |
Case 1 |
- When steering wheel is out of the physical specific range for more than 0.6s
|
| Case 2 |
- When sensor values has changed more than 40degree for more than 0.04s
|
| Case 3 |
- In case that self-failsafe signal fault of SAS was happened for more than specific times within normal voltage condition
|
| Detecting Time |
Case 1 |
|
| Case 2 |
|
| Case 3 |
- While driving or controlling: 0.1s
- While idling: 0.5s
- While initializing MDPS: 1s
|
| Warning Lamp |
|
| Disable Condition |
Case 1, 2 |
- When the normal state is confirmed after the ignition switch turns off and then on (driving over 12KPH)
|
| Case 3 |
- When the normal state is confirmed after the ignition switch turns off and then on
|