| DTC Strategy |
- Pressure sensor monitoring
|
- Electrical noise signal
- Abnormal pressure value due to residual air
- Faulty pressure sensor (built in HECU)
|
| Enable Condition |
- Normal 12V battery voltage (9 to 16V)
- No braking input and motor drive, and it is not low voltage
- APS is more than 40%
|
| Threshold Value |
- When the pressure sensor value is greater than ±15 bars for more than 2s
|
| Warning Lamp |
|
| Disable Condition |
- When pressure sensor value is below 15 bar after driving more than 10KPH (6.21MPH) after the ignition switch turns off and then on
|