| DTC Strategy |
|
- Poor connector connection and open or short circuit
- Wheel speed sensor connector and wire unstable connection
- Water flow into wheel speed sensor connector and wiring
- Open or short in wheel speed sensor circuit
- Faulty wheel speed sensor
- Faulty HECU
|
| Enable Condition |
|
| Threshold Value |
- A failure is detected when the current of WSS is out of specified range of 4.5 to 20 mA longer than 0.2s
|
| Warning Lamp |
1 wheel failure |
|
| 2 or more wheels failure |
|
| Disable Condition |
- When current is normal after the ignition switch turns off and then on
|