Removal & Installation: Installation

NOTE: Rear Corner Radar Type

Use only genuine parts to repair the rear bumper where the rear corner radar is located.
Do not apply license plate molding or foreign objects such as a bumper sticker or a bumper guard near the radar sensor. Doing so may adversely affect the sensing performance of the radar.
The system may not work properly if paint repair is performed near the rear corner radar. Be careful not to use a Polyester putty which has iron content.
The system may not work properly if the rear corner radar is covered with foreign matters, such as snow, rain or dirt, etc.
The system may not work properly if the bumper around the rear corner radar is impacted, damaged or the radar is out of position.
Check if the radar and bracket are damaged after the bumper around the rear corner radar is impacted.
(There must be no mechanical damage near the rear corner radar)