Component Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
SVMS ECU harness connector | 18 (C-CAN high) | SVMS ECU harness connector | 6 (C-CAN low) | Approx. 60Ω |
|
ICU (component side) | 29 (C-CAN high) | ICU (component side) | 30 (C-CAN low) | Approx. 120Ω |
| CLU (component side) | 32 (C-CAN high) | CLU (component side) | 33 (C-CAN low) | Approx. 120Ω | |
Good
- Remove the units connected to CAN one by one and check if communication is possible with KDS. If communication occurs, replace the removed unit and then Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.
- If no problems were found with the circuits or connectors, replace the ICU or CLU and Go to "VERIFICATION OF REPAIR " procedure.