Circuit Inspection

G15720508

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	SVMS ECU harness connector	13 (ON Input)	Chassis ground	-	B+
	SVMS ECU harness connector	1 (ON/START Input)	Chassis ground	-	B+
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	SVMS ECU harness connector	13 (ON Input)	Chassis ground	-	∞ (infinity)Ω
	SVMS ECU harness connector	1 (ON/START Input)	Chassis ground	-	∞ (infinity)Ω
	SVMS ECU harness connector	3 (ground)	Chassis ground	-	Approx. below 1Ω

Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the SVMS ECU and Go to "VERIFICATION OF REPAIR " procedure.

No Good

Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.