Inspection Procedure
- Ignition "OFF".
- Connect KDS.
- Ignition "ON".
- Select "Diagnostic Trouble Codes (DTC)" mode.
- Using a KDS, Clear the DTC.
- Operate the vehicle within DTC detecting condition in general information.
- Select "Diagnostic Trouble Codes (DTC)" mode again.
- Is the same DTC stored in the system?
Good
- Fault might be intermittent and caused either by poor contact in connectors. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the RVM and Go to "VERIFICATION OF REPAIR " procedure.