Main Circuit Inspection
| Inspection Item | Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | |||
| Power inspection (FR_CMR ↔ Chassis ground) |
|
FR_CMR connector | 7 (power) | Chassis ground | - | B+ |
| Open in circuit inspection (FR_CMR ↔ Chassis ground) |
|
FR_CMR connector | 11 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
- If no problems were found with the circuits or connectors, replace the FR_CMR and Go to "VERIFICATION OF REPAIR " procedure.
* In Case of replacing FR_CMR, perform following DTC C110117 "Vehicle S/W Management" procedures.
No Good
- Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.