DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Monitoring CAN messages	Poor connection CAN communication circuit (open, short) CAN high line open CAN low line open CAN high and low line open CAN high line short to 12V battery CAN low line short to 12Vbattery CAN high, low line short to each other CAN high, low line short to each other and short to ground Terminating resistance fault Transmitting controller bus off Transmitting controller disconnected Transmitting controller power, fuse or ground fault Transmitting controller H/W, S/W fault CAN line noise Faulty ICU
Enable Condition	Ignition "ON" (ignition "ON" signal received more than 2s) CAN communication line in normal condition 12V battery voltage is between 9V and 16V
Threshold Value	When CAN message has not been received from ICU via CAN
Diagnosis Time	2s
Symptom	SCC disengagement and shutdown SCC warning lamp turns on NSCC disabled NSCC USM disable
Disable Condition	Normal ICU CAN message received