Circuit Inspection
| Inspection Item | Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | |||
| Power inspection (FR_RDR ↔ Chassis ground) |
|
FR_RDR connector | 6 (power) | Chassis ground | - | B+ |
| Open in circuit inspection (FR_RDR ↔ Chassis ground) |
|
FR_RDR connector | 1 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace FR_RDR and then Go to "VERIFICATION OF REPAIR " procedure.
* If the FR_RDR is replaced, perform the relevant "Vehicle S/W Management" procedure.
No Good
- Check for open or short in harness.
- Repair as necessary and then Go to "VERIFICATION OF REPAIR " procedure.