Module Inspection
| Inspection Item | Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | |||
| Power inspection (ADAS_PRK ↔ Chassis ground) |
|
ADAS_PRK connector | 3, 19 (ON Input) | Chassis ground | - | B+ |
| ADAS_PRK connector | 17 (ACC/ON Input) | Chassis ground | - | B+ | ||
| ADAS_PRK connector | 18 (ON/START Input) | Chassis ground | - | B+ | ||
| Open in circuit inspection (ADAS_PRK ↔ Chassis ground) |
|
ADAS_PRK connector | 5, 21 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
- Carefully re-do this troubleshooting procedure steps.
- If no problems were found with the circuits or connectors, replace the ADAS_PRK and Go to "VERIFICATION OF REPAIR " procedure.
In case of replacing ADAS_PRK, perform following "System Inspection" procedures.
No Good
- Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.