Circuit Inspection
| Inspection Item | Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | |||
| Power inspection (ADAS_PRK ↔ Chassis ground) |
|
ADAS_PRK connector | 3, 17, 18, 19 (power) | Chassis ground | - | B+ |
| Voltage inspection (Rear view camera ↔ Chassis ground) |
|
Rear view camera connector | 7 (video signal) | Chassis ground | - | Approx. 7V |
| Open in circuit inspection (Rear view camera ↔ ADAS_PRK) |
|
Rear view camera connector | 7 (video signal) | ADAS_PRK connector | 1 (video signal) | Approx. below 1Ω |
| Short in circuit inspection (Rear view camera ↔ Chassis ground) |
|
Rear view camera connector | 7 (video signal) | Chassis ground | - | ∞ (infinity)Ω |
Good
- Carefully re-do this troubleshooting procedure steps.
- If no problems were found with the circuits or connectors, replace the rear view camera and Go to "VERIFICATION OF REPAIR " procedure.
After rear view camera replacement, refer to the C110417 data to perform S/W Management.
No Good
- Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.