Component Inspection: Notes

Inspection Condition	Inspection Procedure	Reference
Ignition "ON"	Ignition "ON". ADAS_PRK switch "ON". Check the ADAS_PRK screen output to the head unit display. Check the front, rear, right, and left output images to confirm the wide-angle camera location where abnormalities are identified.	Fig.1

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault might be caused by not performing SVMS calibration after camera or ADAS PRK replacement.
Go to "VERIFICATION OF REPAIR " procedure.

No Good

Carefully re-do this troubleshooting procedure steps.
If problems still occurs, replace camera and then Go to "VERIFICATION OF REPAIR " procedure.

If a module is replaced, perform the relevant "Vehicle S/W Management" procedure.