Main Circuit Inspection
| Inspection Item | Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | |||
| Power inspection (ADAS_DRV ↔ Chassis ground) |
|
ADAS_DRV connector | 7 (power) | Chassis ground | - | B+ |
| Open in circuit Inspection (ADAS_DRV ↔ Chassis ground) |
|
ADAS_DRV connector | 6 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
- If no problems were found with the circuits or connectors, replace the ADAS_DRV ECU and Go to "VERIFICATION OF REPAIR " procedure.
* In case of replacing ADAS_DRV ECU, perform following "System Inspection" procedures
No Good
- Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.