Circuit Inspection
| Inspection Item | Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | |||
| Open in circuit inspection (Rear combination lamp (out) RH ↔ ICU) |
|
Rear combination lamp (out) RH connector | 3 (power) | ICU connector | 43 (Rear combination lamp (out) RH) | Approx. below 1Ω |
Good
- If no problems were found with the circuits or connectors, replace the LED or lamp module and Go to "VERIFICATION OF REPAIR " procedure.
- If the problem still occurs, replace the ICU and Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Repair open or short in circuit and then Go to "VERIFICATION OF REPAIR " procedure.