DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Check the CAN communication	Poor connection CAN communication circuit (open, short) CAN high line open CAN low line open CAN high and low line open CAN high line short to 12Vbattery CAN low line short to 12Vbattery CAN high, low line short to each other CAN high, low line short to each other and short to ground Terminating resistance fault Transmitting controller bus off Transmitting controller disconnected Transmitting controller power, fuse, ground fault Transmitting controller H/W, S/W fault CAN line noise
Enable Condition	Ignition "ON" Normal 12V battery voltage (9 to 16V)
Threshold Value	Received error "Low" to M-CAN transceiver
Detecting Time	2s
DTC Erasing	When the message is received normally