DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Check the CAN communication	Poor connection CAN communication circuit (open, short) CAN high line open CAN low line open CAN high and low line open CAN high line short to 12Vbattery CAN low line short to 12Vbattery CAN high, low line short to each other CAN high, low line short to each other and short to ground Terminating Resistance fault Transmitting controller bus off Transmitting controller disconnected Transmitting controller power, fuse or ground fault Transmitting controller H/W, S/W fault CAN line noise
Enable Conditions	Ignition "ON" Normal 12V battery voltage (9 to 16V)
Threshold Value	M-CAN message is not received
Detecting Time	2s
Clear Condition	M-CAN message received normally