Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Anti-Pinch sensor LH | 2 (power) | Chassis ground | - | B+ |
|
Anti-Pinch sensor LH | 1 (ground) | Chassis ground | - | Approx. below 1Ω |
| Anti-Pinch sensor LH | 2 (power) | Anti-Pinch sensor | 1 (ground) | ∞ (infinity)Ω | |
Good
- Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.
No Good
- Perform the relevant diagnostic procedure.
- If the symptoms persist, replace left APS and perform the relevant procedure.