Head Up Display (HUD) Unit: Adjustment

If a part of the head up display footage is distorted or it is not at eye level with the driver a KDS can be used to perform calibration.

1. Calibration is required
   • After replacing the head-up display unit
   • When the footage is distorted after replacing the windshield (double vision removal film built-in glass)
   • When the HUD mounted main crash pad is removed/installed or replaced
   • When the image setting location of the HUD unit is not at eye level of the driver resulting in out of focus image
2. Calibration items

   No	Footage calibration functions
   1	Horizontal rotation: Set the horizontal rotation on the screen
   2	Upward/downward: Set the upward and downward directions on the screen
   3	Slope (up/down): Set the slope on the screen
   4	Parallel slope: Set the parallel slope on the screen
   5	Vertical movement: Set the vertical movement on the screen
   6	Slope (left/right): Set the slope on the screen
   7	Width: Set the width of the screen
   8	Height: Set the height of the screen
   9	Initialization: Return to previous status before calibration.

3. Process of calibration
   1. Locate the vehicle on a flat plane for accurate adjustment.
   2. Make sure that there are no foreign materials on the windshield.
   3. Select the "HUD Calibration" on the menu by using the KDS.

      (S/W Management → Head Up Display → HUD Calibration)

      NOTE: 'HUD calibration - initialization' must be performed prior to 'calibration'.

      Information 

      Refer to the KDS screen for operating conditions and details

   4. When calibration is completed, start and turn off the engine and check that the footage calibration is completed.