Module Inspection

Inspection Item	Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Item	Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Power inspection (UWB front (frunk) ↔ Chassis ground)	Disconnect the UWB front (frunk) connector. Ignition "ON".	UWB front (frunk) connector	8 (Memory power)	Chassis ground	-	B+
Open in circuit inspection (UWB front (frunk) ↔ Chassis ground)	Ignition "OFF". Disconnect the UWB front (frunk) connector.	UWB front (frunk) connector	5, 6, 7 (ground)	Chassis ground	-	Approx. below 1Ω

Good	Go to "UWB L-CAN INSPECTION " procedure.
No Good	Repair as necessary and Go to "VERIFICATION OF REPAIR " procedure.