LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2024 >> EV9 GT-Line >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Ultra Wide Band BLUETOOTH Low Energy-Slave Diagnosis >> DTC B16CC-00: BLE2 Module Fault (Slave) >> Wiring Inspection >> Circuit Inspection

Circuit Inspection

G16873207Courtesy of KIA MOTORS AMERICA, INC.
Inspection Item Inspection Condition (+) Probe (-) Probe Specification
Connector Terminal Connector Terminal
Power inspection (UWB_BLE unit#2 ↔ Chassis ground)
  1. Disconnect the UWB_BLE unit#2 connector.
  2. Ignition "ON".
 UWB_BLE unit#2 connector 1 (power) Chassis ground - B+
Open in circuit inspection (UWB_BLE unit#2 ↔ Chassis ground)
  1. Ignition "OFF".
  2. Disconnect the UWB_BLE unit#2 connector.
 UWB_BLE unit#2 connector 6 (ground) Chassis ground - Approx. below 1Ω
Good 
  • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of 12V battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
  • Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.
No Good 
scientia non olet · About LEMON Manuals