Circuit Inspection

Courtesy of HYUNDAI MOTOR AMERICA

Inspection Item	Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Item	Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Power inspection (UWB_BLE unit#1 ↔ Chassis ground)	Disconnect the UWB_BLE unit#1 connector. Ignition "ON".	UWB_BLE unit#1 connector	1 (power)	Chassis ground	-	B+
Open in circuit inspection (UWB_BLE unit#1 ↔ Chassis ground)	Ignition "OFF". Disconnect the UWB_BLE unit#1 connector.	UWB_BLE unit#1 connector	6 (ground)	Chassis ground	-	Approx. below 1Ω

Good	Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. Repair or replace as necessary and then Go to "VERIFICATION OF REPAIR " procedure.
No Good	Repair as necessary and Go to "VERIFICATION OF REPAIR " procedure.